S'2 WEEK 9 => 11 MARCH - 17 MARCH

VOLTAGE REGULATOR

The voltage regulator module is used to protect PIC and other connected sensors / actuators from over voltage. This is because PIC and all other connected sensors, actuators all support 5V DC only. Over voltage will cause any of the module burn.

 Voltage Regulator

LM7805 is used to regulate voltage in the system and output 5V DC (max output current: 1000mA). It supports input voltage from 7V DC to 18V DC. If the input voltage is over, the LM7805 will burn or auto shutdown due to overheat. The generated 5V from LM7805 will be noise filtered by 0.1uF ceramic capacitor and a 1000uF electrolytic capacitor. This is to avoid high frequency oscillation on the outputs which may cause system hang or unstable.

The voltage regulator module is used to protect PIC and other connected sensors / actuators from over voltage. This is because PIC and all other connected sensors, actuators all support 5V DC only. Over voltage will cause any of the module burn.

LM7805 is used to regulate voltage in the system and output 5V DC (max output current: 1000mA). It supports input voltage from 7V DC to 18V DC. If the input voltage is over, the LM7805 will burn or auto shutdown due to overheat.

The generated 5V from LM7805 will be noise filtered by 0.1uF ceramic capacitor and a 1000uF electrolytic capacitor. This is to avoid high frequency oscillation on the outputs which may cause system hang or unstable.

A diode is connected at the input of the LM7805. This is to avoid voltage connected reversely. An on/off switch is used to turn on/off the system and a LED (5V, 5mA) is used to indicate the system is power on/off. The LED is connected through 1KR resistor to limit current pass through LED is 5mA.

Posted in: